reprap:anet:a8

This is an old revision of the document!


Anet A8

Calibration is normally not needed as this is carried out by the manufacturer and stored in the factory installed firmware. Information on printer calibration:

Sometimes the center of the bed is not the actual center. When printing large prints, the skirt, brim or the object itself is printed outside the heated bed. For bed center offset calibration please read:

Frame Stabilization

Belt holder & tensioner

Cases & Covers

Z-Endstops

others

  • WiFi Printing Mod - add WiFi capabilities to your Anet A8 3D printer using cheap ESP-01 (ESP8266) module
  • Laser Engraver Mod - turn your Anet A8 3D printer into cheap laser engraver

Extruder

Part Description Where to buy?
Belts
Heater Block
Mainboard
PSU
Throat
Nozzle
Extruder
Linear Bearings
Linear Bearings Upgrade
Heatbed Upgrade
Thermistor for Heatbed
Blower fan
  • reprap/anet/a8.1588800270.txt.gz
  • Last modified: 2020/05/06 21:24
  • by joe.wobb