XVICO X3 Pro

• Manufacturer xvico3d.com

These are the most asked questions when assembling

Calibration is normally not needed as this is carried out by the manufacturer and stored in the factory installed firmware. Information on printer calibration:

• Triffid Hunter's Calibration Guide on reprap.org

Sometimes the center of the bed is not the actual center. When printing large prints, the skirt, brim or the object itself is printed outside the heated bed. For bed center offset calibration please read:

• 0scar's Calibration Guide on Thingiverse

• RAMPS 1.4

• Ikea Lack Enclosure - cheap enclosure for Anet A8 using Ikea Lack tables dead link (on archive.org)
• Original Prusa i3 MK3 ENCLOSURE -Ikea Lack table - Another enclosure
• You can also buy different type of enclosures & kits from https://3dsourcerer.com/

• Increasing Voltage On the stock PSU

• Set to Creality CR-10 in Cura.

• Facebook group: XViCO 3D printer owners