reprap:wanhao:duplicator6:purchaseable_upgrade_parts

This is an old revision of the document!


Purchasable Upgrade Parts

Replacement Fans

Nicer Table with Clickable Store Links

Click here to view or edit in Google Docs

Stock PartUpgrade Part
Nozzle.4mm MK10/MK11Micro Swiss All Metal Kit - $65 USDTriangle Labs Version (Less Parts) - $15 USD
Heater40 watt 6mm cartridge24V 50W heater
Heater Block Insulation/"Sock"n/aHigh Temp Silicone Nozzle Tips
Temp ProbePT100 ThermocouplePT100 Temperature sensor 3mm*30mm Platinum Resistance RTD Stainless Steel Probe 1m High Temperature 2 Wire -40~400 C Degree
Power Supply350W 24V Mean Well LRS-350-24?
Heat BlockMK11 Hot End Aluminum BlockMicro Swiss All Metal Kit
Build Plate Surface3M Heating Board PlateBorax Glass Plate + Silicone Thermal Adhesive+ Silicone Thermal Adhesive
Extruder FansAAA 40mm x 40mm x 10mm 24v Brushless Sleeve Bearing Fan (HZHZ 4010MS, DC24V, 0.12Amax) w/ 185mm power cable24V DC Brushless Blower Cooling Fan 50x50x15mm
Motherboard FanAAA 40mm x 40mm x 10mm 24v Brushless Sleeve Bearing Fan (HZHD 4010MS, DC24V, 0.12Amax) w/ 250mm power cable24V DC Brushless Blower Cooling Fan 50x50x15mm
Guide TubeMK10/11 Guide Tube for PTFEPTFE Teflon Tube OD 4mm ID 2mm
MotherboardD6 Motherboard (ATMEGA 2560 based)?
Control BoardLCD and SD card control board?
End StopsCGC 5A 125-250V 10T85 Normally Closed Switch
Extruder BoardInterface Panel/Keyset/Patching BoardFlat Ribbon Cable 16 Cond2x8 Pin Female Header IDC Cable Connector
X/Y Axis MotorNEMA 17 StepperHybrid Steppers
Z Axis MotorNEMA 17 StepperHybrid Steppers
Extruder MotorNEMA 17 Stepper
Extruder Gear5mm 40T Extruder Driver Feeder Gear Bore
Motor Dampersn/aNEMA 17 Steel & Rubber Stepper Motor Vibration DamperNeed to print adapters, many to choose from on thingiverse
LED Lighting24v LED strip DC 24V 12W SMD3528 150LEDs IP68 Waterproof
BearingsIgnus Drylin
Z-ProbeNone on the D6See page about Z-probe upgrading

Rods/Shafts

Check if your 8mm linear rods are straight

Bearings

Smooth operation requires straight and true (no bends or kinks) shafts and properly lubricated bearings.

(4) x LM6LUU Linear Bearings - for the extruder gantry (35mm long) SKF

(8) x KFL08 Flanged Pillow Block Bearings

(4) x LMK12UU Flanged Linear Bearings - for the Z axis

  • reprap/wanhao/duplicator6/purchaseable_upgrade_parts.1547020517.txt.gz
  • Last modified: 2019/01/09 07:55
  • by champatron