Purchasable Upgrade Parts
Nicer Table with Clickable Store Links
Click here to view or edit in Google Docs
| Stock Part | Upgrade Part | |||||
|---|---|---|---|---|---|---|
| Nozzle | .4mm MK10/MK11 | Micro Swiss All Metal Kit - $65 USD | Triangle Labs Version (Less Parts) - $15 USD | |||
| Heater | 40 watt 6mm cartridge | 24V 50W heater | ||||
| Heater Block Insulation/"Sock" | n/a | High Temp Silicone Nozzle Tips | ||||
| Temp Probe | PT100 Thermocouple | PT100 Temperature sensor 3mm*30mm Platinum Resistance RTD Stainless Steel Probe 1m High Temperature 2 Wire -40~400 C Degree | ||||
| Power Supply | 350W 24V Mean Well LRS-350-24 | ? | ||||
| Heat Block | MK11 Hot End Aluminum Block | Micro Swiss All Metal Kit | ||||
| Build Plate Surface | 3M Heating Board Plate | Borax Glass Plate + Silicone Thermal Adhesive | + Silicone Thermal Adhesive | |||
| Extruder Fans | AAA 40mm x 40mm x 10mm 24v Brushless Sleeve Bearing Fan (HZHZ 4010MS, DC24V, 0.12Amax) w/ 185mm power cable | 24V DC Brushless Blower Cooling Fan 50x50x15mm | ||||
| Motherboard Fan | AAA 40mm x 40mm x 10mm 24v Brushless Sleeve Bearing Fan (HZHD 4010MS, DC24V, 0.12Amax) w/ 250mm power cable | 24V DC Brushless Blower Cooling Fan 50x50x15mm | ||||
| Guide Tube | MK10/11 Guide Tube for PTFE | PTFE Teflon Tube OD 4mm ID 2mm | ||||
| Motherboard | D6 Motherboard (ATMEGA 2560 based) | ? | ||||
| Control Board | LCD and SD card control board | ? | ||||
| End Stops | CGC 5A 125-250V 10T85 Normally Closed Switch | |||||
| Extruder Board | Interface Panel/Keyset/Patching Board | Flat Ribbon Cable 16 Cond | 2x8 Pin Female Header IDC Cable Connector | |||
| X/Y Axis Motor | NEMA 17 Stepper | Hybrid Steppers | ||||
| Z Axis Motor | NEMA 17 Stepper | Hybrid Steppers | ||||
| Extruder Motor | NEMA 17 Stepper | |||||
| Extruder Gear | 5mm 40T Extruder Driver Feeder Gear Bore | |||||
| Motor Dampers | n/a | NEMA 17 Steel & Rubber Stepper Motor Vibration Damper | Need to print adapters, many to choose from on thingiverse | |||
| LED Lighting | 24v LED strip | DC 24V 12W SMD3528 150LEDs IP68 Waterproof | ||||
| Bearings | Ignus Drylin | |||||
| Z-Probe | None on the D6 | See page about Z-probe upgrading |
Rods/Shafts
Check if your 6mm and 8mm linear rods are straight
Bearings
Smooth operation requires straight and true (no bends or kinks) shafts and properly lubricated bearings.
(4) x LM6LUU Linear Bearings - for the extruder gantry (35mm long)
(8) x KFL08 Flanged Pillow Block Bearings
(4) x LMK12UU Flanged Linear Bearings - for the Z axis