TEVO Tarantula

• Manufacturer TEVO
• Specification and technical parameters

• ArcadEd's Tarantula Assembly Videos (With instructions).
• RCJOSEB's Tarantula Assembly Videos (With instructions).
• ruiraptor's Tarantula Assembly Videos (Without instructions).

These are the most asked questions.

• Bed level sensor (BL Touch)

Calibration is normally not needed as this is carried out by the manufacturer and stored in the factory installed firmware. Information on printer calibration:

• Triffid Hunter's Calibration Guide on reprap.org

Sometimes the center of the bed is not the actual center. When printing large prints, the skirt, brim or the object itself is printed outside the heated bed. For bed center offset calibration please read:

• KevPV's Calibration Guide on Thingiverse

• Additional Print Quality Troubleshooting on 3DVerkstan

• Raspberry Pi 3

• ON/OFF Switch for PSU (Power Box Adapter)
• MOSFET
• Howto: Replace the heat bed connector

• Tarantula firmware
• Marlin 3D printer firmware.
• JimBrown's Modified Marlin firmware

• Howto: Thumbwheel Leveling
• Howto: Auto bed leveling
• Howto: Manual level video

• Thingirob's Frame Stabilization Brackets (Most Popular).

• Banholm's Y-Belt Tensioner.
• Banholm's X-Belt Tensioner.

• Joshfitz's 40mm Tarantula Fan Cover.
• supasorn's Dual Blower/Radial Fan Duct Mount.
• Lion4H's Radial Fan Fang (Most Popular).
• hafidz's Standard 40mm Fang (Alternate design for standard fan)
• Joshfitz's Tarantula Cover For 5015 Radial Blower Fan.

• filamentry's Ultimate Spool Holder.
• Madox's Filament Clip
• RCLifeOn's Spool Holder (Not Recommended).
• JeramZ's Spool Holder (Not Recommended).

• Aynareth's Electronics Enclosure.
• boompy's Power Supply Brackets.
• beerman_uk's Tarantula-themed Power Supply Brackets.

• NinjaCookie's Dual Z-axis 1 Mmotor Frame-Brackets.
• Joshfitz's Tarantula-themed Bedlevel Knobs.
• rebeltaz's PTFE Tube Guillotine Cutter

• Taralu.net

• WiFi
• Laserprinting
• Woodburning

• IKEA Lack Enclosure - Cheap enclosure for TEVO Tarantula using IKEA Lack tables.

• 5015 12V Blower

• Cura
• S3D
• IdeaMaker
• Slic3r