This is an old revision of the document!


Howto install the z-couplers (the right way)

Z-axis coupler beauty shot

Couplers connect the motor to the threaded rods that move your z-axis up and down. If the motor and the rod are not perfectly aligned, the rotation of the motor will apply force to the rod and push it into x and y direction. This leads to the so called z-wobble and slightly shifted layers.

It's simple: The middle of the coupler must be flexible. So don't insert the rods until they touch each other, just insert the rods on both sides for 5mm. They have to get in touch with the screws, but they dont need go in all the way.

A simple illustration:

Applied z-coupler with marks for right insertion

The green marks show how deep the rods should sit in the coupler. The red mark shows where they shall not pass. ;)

Remeber to tighen the screws on the coupler over cross. An example would be:

1 (first screw)3(third screw)
4(last screw)2(second screw)

There are many reasons for unwanted movements. Take a look at the troubleshooting, print some frame stabilizations and tighten your belts.

  • reprap/anet/a8/coupler.1480018237.txt.gz
  • Last modified: 2018/12/02 02:27
  • (external edit)