These are the most asked questions when assembling
Calibration is normally not needed as this is carried out by the manufacturer and stored in the factory installed firmware. Information on printer calibration:
Sometimes the center of the bed is not the actual center. When printing large prints, the skirt, brim or the object itself is printed outside the heated bed. For bed center offset calibration please read:
| Part | Description | Where to buy? |
|---|---|---|
| Belts | GT2 6 mm Belt (recomended glass fiber reinforced) | ebay |
| Heater Block | Aluminium Heater Block | aliexpress |
| Mainboard Anet V 1.0 | Anet 3d printer mainboard | Banggood |
| PSU | 12 V, 20A, 240W Power Supply Unit | aliexpress |
| Throat | Throat with PTF Tube inside. M6 Thread, 30 mm | ebay |
| Nozzle | 0.4 mm MK8 Nozzle for 1.75 mm filament | ebay |
| Extruder | MK8 Extruder | aliexpress |
| Linear Bearings | LM8UU | ebay |
| Linear Bearings Upgrade | Igus RJ4JP-01-08 | ebay |
| Heatbed Upgrade | MK3 | ebay |
| Thermistor for Heatbed | NTC 3950 | Banggood |
| Blower fan | Anet 5015 | aliexpress |