Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| reprap:wanhao:duplicator6:how-to_guides:properly_tighten_nozzle_heat_block_heat_tube_assembly [2018/05/23 06:48] – champatron | reprap:wanhao:duplicator6:how-to_guides:properly_tighten_nozzle_heat_block_heat_tube_assembly [2018/05/23 06:49] – champatron | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| - | ^ What you don't want to happen! ^^^ | + | ^ What you don't want to happen... ^^^ |
| | | | | ||
| - | |left | | + | |
| - | | xxxxxxxxxxxx | xxxxxxxxxxxx | xxxxxxxxxxxx | | + | In the above photos, the assembly was not tightened while hot, so there were small gaps between the heat tube, heat block, and nozzle which the molten filament was able to escape through. To avoid this, follow the below procedure: |