Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
reprap:wanhao:duplicator6:how-to_guides:properly_tighten_nozzle_heat_block_heat_tube_assembly [2018/05/23 06:43] – champatron | reprap:wanhao:duplicator6:how-to_guides:properly_tighten_nozzle_heat_block_heat_tube_assembly [2018/05/23 06:49] – champatron | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== How to Properly Tighten the Nozzle+Heat Block+Heat Tube Assembly ====== | ====== How to Properly Tighten the Nozzle+Heat Block+Heat Tube Assembly ====== | ||
- | What you don't want to happen! | + | |
- | {{ : | + | ^ |
- | {{: | + | | {{: |
+ | |||
+ | In the above photos, the assembly was not tightened while hot, so there were small gaps between the heat tube, heat block, and nozzle which the molten filament was able to escape through. To avoid this, follow the below procedure: | ||
- | {{: | ||
- | {{: | ||
=== Proper Procedure === | === Proper Procedure === | ||
blah | blah |