Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revisionBoth sides next revision | ||
reprap:wanhao:duplicator6:troubleshooting [2018/05/16 18:15] – created champatron | reprap:wanhao:duplicator6:troubleshooting [2018/05/16 18:17] – champatron | ||
---|---|---|---|
Line 4: | Line 4: | ||
- | ERROR - STOPPED - Temp Sensor | + | === ERROR - STOPPED - Temp Sensor |
- | ERROR - STOPPED - X or Y Switch Broken | + | === ERROR - STOPPED - X or Y Switch Broken |
- | ERROR - STOPPED - Z Switch Broken | + | === ERROR - STOPPED - Z Switch Broken |
- | ERROR - STOPPED - Heater Error | + | === ERROR - STOPPED - Heater Error === |
+ | |||
1. Ensure temp probe and heater are fully and securely inserted into the heat block. There are tiny screws in the sides for you to tighten with but if that isn't helping I recommend thermal grease to get them stuck in there snug. | 1. Ensure temp probe and heater are fully and securely inserted into the heat block. There are tiny screws in the sides for you to tighten with but if that isn't helping I recommend thermal grease to get them stuck in there snug. | ||
2. Make sure the two wires from the heater and temp probe are securely connected to the board on top of the extruder. | 2. Make sure the two wires from the heater and temp probe are securely connected to the board on top of the extruder. |