Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
reprap:wanhao:duplicator6:specifications [2018/05/16 16:13]
champatron
reprap:wanhao:duplicator6:specifications [2018/12/02 01:27] (current)
Line 53: Line 53:
   * Travel Speed: 30mm - 150mm/s   * Travel Speed: 30mm - 150mm/s
   * Extruder Temperature Range: 180degC - **200degC (Above 200degC, the PTFE tube in the heat block will begin breaking down, causing clogs and releasing toxic? gases)**   * Extruder Temperature Range: 180degC - **200degC (Above 200degC, the PTFE tube in the heat block will begin breaking down, causing clogs and releasing toxic? gases)**
- +  ​* Heated Build Plate Temp Range: 50degC ​**120degC**
-                                                  ** __ HIGHLY RECOMMEND ALL METAL HOT END UPGRADE! __ ** +
-  +
-  ​* Heated Build Plate Temp Range: 50degC** ​120degC**+
  
 Physical Dimensions: Physical Dimensions:
Line 69: Line 66:
   * Ambient Operating Temperature:​ 15degC - 32degC   * Ambient Operating Temperature:​ 15degC - 32degC
   * Storage Temperature:​ 0degC - 32degC   * Storage Temperature:​ 0degC - 32degC
-  * Average Noise Level: 49dB (Much quieter after installing motor dampers)+  * Average Noise Level: 49dB **(Much quieter after installing motor dampers)**
  
 Electrical Specifications:​ Electrical Specifications:​
  
   * AC Outlet Input: 100-240V, 50-60Hz   * AC Outlet Input: 100-240V, 50-60Hz
-  * Power Consumption:​ ~4 Amps, ~300 Watt Max (when both heaters are active)+  * Power Consumption:​ ~4 Amps, **~300 Watt Max (when both heaters are active)**
  
  
  • reprap/wanhao/duplicator6/specifications.txt
  • Last modified: 2018/12/02 01:27
  • (external edit)