Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| reprap:wanhao:duplicator6:how-to_guides:properly_tighten_nozzle_heat_block_heat_tube_assembly [2018/05/23 06:58] – champatron | reprap:wanhao:duplicator6:how-to_guides:properly_tighten_nozzle_heat_block_heat_tube_assembly [2018/05/23 06:59] – champatron | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| In the above photos, the assembly was not tightened while hot, so there were small gaps between the heat tube, heat block, and nozzle which the molten filament was able to escape through. To avoid this, follow the below procedure: | In the above photos, the assembly was not tightened while hot, so there were small gaps between the heat tube, heat block, and nozzle which the molten filament was able to escape through. To avoid this, follow the below procedure: | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | === Proper Procedure === | ||
| + | |||
| - Assembly the heat tube (silver tube part that sticks up into the extruder body) into the heat block (aluminum or brass middle part with the heater and thermister installed) and the nozzle into the heat block fairly tightly with just your fingers. | - Assembly the heat tube (silver tube part that sticks up into the extruder body) into the heat block (aluminum or brass middle part with the heater and thermister installed) and the nozzle into the heat block fairly tightly with just your fingers. | ||
| Line 14: | Line 20: | ||
| - | + | == References | |
| - | + | https:// | |
| - | + | ||
| - | === Proper Procedure | + | |
| - | + | ||
| - | blah | + | |