reprap:tevo:tarantula

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Last revisionBoth sides next revision
reprap:tevo:tarantula [2017/12/26 11:27] – Add alternate 40mm fan duct design for flat fans, this isnt the best one I'm sure, but I printed it and it works, despite hard to cut centre out. binaryjamreprap:tevo:tarantula [2019/08/18 16:50] – [General Info] darkburrow
Line 5: Line 5:
   * [[reprap:tevo:tarantula:Specification|Specification and technical parameters]]   * [[reprap:tevo:tarantula:Specification|Specification and technical parameters]]
  
 +RAWR !
 ===== Guides ===== ===== Guides =====
 ====Assembly videos from TEVO/YouTube ==== ====Assembly videos from TEVO/YouTube ====
Line 25: Line 26:
  
 ==== Print quality troubleshooting ==== ==== Print quality troubleshooting ====
-  * [[https://www.simplify3d.com/support/print-quality-troubleshooting/|Print Quality Troubleshooting Guide on simplify3d.com]] 
   * [[http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide|Additional Print Quality Troubleshooting on 3DVerkstan]]   * [[http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide|Additional Print Quality Troubleshooting on 3DVerkstan]]
  
Line 140: Line 140:
 ===== Links ===== ===== Links =====
 ==== Communities ==== ==== Communities ====
-  *  +  * [[https://www.facebook.com/groups/TEVO.3dprinter.owners/|TEVO Tarantula PRO & Normal Prusa i3 Owners]] on Facebook 
-  *  +
-  * +
  • reprap/tevo/tarantula.txt
  • Last modified: 2019/08/18 17:05
  • by darkburrow