Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
reprap:firmware:calibration [2016/11/06 14:00] – ender | reprap:firmware:calibration [2016/11/06 14:35] – ender | ||
---|---|---|---|
Line 56: | Line 56: | ||
**NOTE**: This setting will not persist! You will have to either set the setting in the EEPROM (through printer menus) or in '' | **NOTE**: This setting will not persist! You will have to either set the setting in the EEPROM (through printer menus) or in '' | ||
+ | To save the setting in '' | ||
+ | <code c> | ||
+ | #define DEFAULT_AXIS_STEPS_PER_UNIT | ||
+ | </ | ||
+ | |||
+ | ===== XY Calibration ===== |