Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
reprap:anet:a8:nozzle [2019/01/03 09:26]
cj_elec_tech [Leaking filament]
reprap:anet:a8:nozzle [2019/01/03 09:29] (current)
cj_elec_tech [Leaking filament]
Line 17: Line 17:
 Usually at one end of the throat the PTFE Tube comes out slightly, this is the end that has to touch the nozzle inside the heaterblock. On the other end, the tube is not aligned with the throat and has a 40° countersink to guide the Filament into the tube - this is the end that sticks out of the extruder. ​ Usually at one end of the throat the PTFE Tube comes out slightly, this is the end that has to touch the nozzle inside the heaterblock. On the other end, the tube is not aligned with the throat and has a 40° countersink to guide the Filament into the tube - this is the end that sticks out of the extruder. ​
  
-If it still leaks, heat up the hotend and tighten the nozzle against the throat.+If it still leaks, heat up the hotend and tighten the nozzle against the throat ​even more.
  
 {{:​reprap:​anet:​a8:​hotend.png?​200|}} {{:​reprap:​anet:​a8:​hotend.png?​200|}}
  • reprap/anet/a8/nozzle.txt
  • Last modified: 2019/01/03 09:29
  • by cj_elec_tech