Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
reprap:anet:a8:layer-heights [2017/01/11 23:26] – old revision restored (2016/12/28 12:15) nerolauda | reprap:anet:a8:layer-heights [2017/01/20 09:20] – nerolauda | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Valid Layer Heights ====== | ====== Valid Layer Heights ====== | ||
+ | Based on the pitch 2.0 mm of **the default Anet A8 Z-Axis leadscrew** 300mm T8, the Z-Motor 200 steps per revolution , and [[http:// | ||
+ | In phew words you can proceed by 0.01 steps. | ||
+ | |||
+ | Instead if you adopted threaded rods M8, the pitch is 1.25mm and valid layer heights are: ** 0.0125, ..., 0.025,..., 0.05, ...,0.1, ... ,0.2, ...** each sum or multiple of this values are exact steps counts. | ||
- | Based on the pitch 1.25mm of the Anet A8 Z-Axis threaded rods M8, the Z-Motor 200 steps per revolution , and [[http:// | ||
PLS DO NOT RESTORE WRONG VALUES | PLS DO NOT RESTORE WRONG VALUES |