reprap:anet:a8:layer-heights

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
reprap:anet:a8:layer-heights [2016/12/16 14:02] loksterreprap:anet:a8:layer-heights [2017/01/20 09:20] nerolauda
Line 1: Line 1:
 ====== Valid Layer Heights ====== ====== Valid Layer Heights ======
 +Based on the pitch 2.0 mm of **the default Anet A8 Z-Axis leadscrew** 300mm T8, the Z-Motor 200 steps per revolution , and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of valid layer heights: ** 0.1, 0.11, 0.12 ..., 0.2,..., 0.3 **.
 +In phew words you can proceed by 0.01 steps.
  
-Based on the pitch of the Anet A8 Z-Axis threaded rods (8mm), the Z-Motor steps per revolution (200), and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]] we can calculate the list of valid layer heights: **0.080.12, 0.160.20, 0.24, 0.28, 0.32** etc.+Instead if you adopted threaded rods M8, the pitch is 1.25mm and valid layer heights are: ** 0.0125, ..., 0.025,..., 0.05, ...,0.1, ... ,0.2, ...** each sum or multiple of this values are exact steps counts. 
 + 
 +PLS DO NOT RESTORE WRONG VALUES
  • reprap/anet/a8/layer-heights.txt
  • Last modified: 2018/12/02 02:27
  • by 127.0.0.1