Differences

This shows you the differences between two versions of the page.

--- reprap:anet:a8:layer-heights [2016/12/16 14:02] – created lokster
+++ reprap:anet:a8:layer-heights [2017/01/20 09:20] – nerolauda
@@ Line 1: / Line 1: @@
-Based on the pitch of the Anet A8 Z-Axis threaded rods (8mm), the Z-Motor steps per revolution (200), and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]] we can calculate the list of valid layer heights: **0.08, 0.12, 0.16, 0.20, 0.24, 0.28, 0.32** etc.
+====== Valid Layer Heights ======
+Based on the pitch 2.0 mm of **the default Anet A8 Z-Axis leadscrew** 300mm T8, the Z-Motor 200 steps per revolution , and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of valid layer heights: ** 0.1, 0.11, 0.12 ..., 0.2,..., 0.3 **.
+In phew words you can proceed by 0.01 steps.
+Instead if you adopted threaded rods M8, the pitch is 1.25mm and valid layer heights are: ** 0.0125, ..., 0.025,..., 0.05, ...,0.1, ... ,0.2, ...** each sum or multiple of this values are exact steps counts.
+PLS DO NOT RESTORE WRONG VALUES