Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
printers:parts:beds:glass [2017/04/28 10:01] – sjouke | printers:parts:beds:glass [2021/08/17 09:45] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 4: | Line 4: | ||
Sometimes the aluminium buildplate will get warped through heat, or some of them are warped from new. | Sometimes the aluminium buildplate will get warped through heat, or some of them are warped from new. | ||
- | The glass will provide a nice flat surface to print on, second the printed object will get that very nice mirrorlike finish on the bottomlayer (if buildplate levelled ok) | + | The glass will provide a nice flat surface to print on, second the printed object will get that very nice mirrorlike finish on the bottomlayer (if the buildplate |
- | 10,5 cm tall figurewith | + | 10,5 cm tall figure with moving joints |
+ | |||
+ | {{: | ||
**There are many solutions to printing on glass, i will name the most simple one(s)** | **There are many solutions to printing on glass, i will name the most simple one(s)** | ||
Line 25: | Line 27: | ||
Clamps for the glass placed left back and right front are almost never "in the way" of the moving extruderhead and 2 should be enough to hold the glass in place. | Clamps for the glass placed left back and right front are almost never "in the way" of the moving extruderhead and 2 should be enough to hold the glass in place. | ||
- | {{: | + | {{: |