Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
printers:parts:beds:glass [2017/04/24 12:56] – sjouke | printers:parts:beds:glass [2017/04/24 13:03] – sjouke | ||
---|---|---|---|
Line 19: | Line 19: | ||
{{: | {{: | ||
- | If and when the glass gets dirty, just clean it unbder | + | If and when the glass gets dirty, just clean it under a running tap with some hot water, the hairspray will dissolve very quick and the bits that do not remove themself you can wipe away with an abrasive sponge (not steelwoll). |
Clamps for the glass placed left back and right front are almost never "in the way" of the moving extruderhead and 2 should be enough to hold the glass in place. | Clamps for the glass placed left back and right front are almost never "in the way" of the moving extruderhead and 2 should be enough to hold the glass in place. | ||
- | {{: | + | {{: |