Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
| firmware:klipper:bltouch-with-raspberry-pi [2022/03/16 20:04] – [Testing the Probe] vidschofelix | firmware:klipper:bltouch-with-raspberry-pi [2022/03/16 20:05] – [Attaching the BLTouch] vidschofelix | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| ==== Attaching the BLTouch ==== | ==== Attaching the BLTouch ==== | ||
| - | * remove the red pin from the triple-connection cable and put it into a single dupont case | + | * remove the red pin from the triple-connection cable and put it into a single dupont case (included in original BLTouch packaging) |
| * connect the pins to the [[https:// | * connect the pins to the [[https:// | ||
| - | * white -> GPIO | + | * white -> GPIO0 |
| * black -> GND next to GPI0 | * black -> GND next to GPI0 | ||
| * yellow -> GPIO27 | * yellow -> GPIO27 | ||
| Line 19: | Line 19: | ||
| * red -> 3.3V | * red -> 3.3V | ||
| * //Todo: Add a picture of the wires// | * //Todo: Add a picture of the wires// | ||
| - | * you can choose whatever pins you like, but it's easier to follow if you choose the same | + | * you can choose whatever pins you like for control_pin, but it's easier to follow if you choose the same |
| ==== printer.cfg adjustment ==== | ==== printer.cfg adjustment ==== | ||