Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
firmware:klipper:bltouch-with-raspberry-pi [2022/03/16 20:03] – [good choice for sensorpins] vidschofelix | firmware:klipper:bltouch-with-raspberry-pi [2022/03/16 20:04] – [Attaching the BLTouch] vidschofelix | ||
---|---|---|---|
Line 13: | Line 13: | ||
* remove the red pin from the triple-connection cable and put it into a single dupont case | * remove the red pin from the triple-connection cable and put it into a single dupont case | ||
* connect the pins to the [[https:// | * connect the pins to the [[https:// | ||
- | * white -> GPIO | + | * white -> GPIO0 |
* black -> GND next to GPI0 | * black -> GND next to GPI0 | ||
* yellow -> GPIO27 | * yellow -> GPIO27 | ||
Line 46: | Line 46: | ||
==== Testing the Probe ==== | ==== Testing the Probe ==== | ||
* follow the [[https:// | * follow the [[https:// | ||
- | * also make sure, that the bltouch works after firmware restart, klipper restart and restart of the raspberry. If not check your scripts! | ||
- | |||
==== Wrapping it up ==== | ==== Wrapping it up ==== |