Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revisionBoth sides next revision | ||
firmware:klipper:bltouch-wth-raspberry-pi [2022/03/15 02:42] – created vidschofelix | firmware:klipper:bltouch-with-raspberry-pi [2022/03/16 20:00] – [printer.cfg adjustment] vidschofelix | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== HowTo Run BLTouch connected to RPi microcontroller ====== | ====== HowTo Run BLTouch connected to RPi microcontroller ====== | ||
==== Why? ==== | ==== Why? ==== | ||
- | * some printer board dont support the control signal for the bltouch, or need to remove some components. | + | * some printer board dont support the control signal for the bltouch, or need to remove some components. |
==== Needed ==== | ==== Needed ==== | ||
Line 28: | Line 28: | ||
[bltouch] | [bltouch] | ||
- | sensor_pin: ^rpi:gpio12 | + | sensor_pin: ^rpi:gpio0 |
# Pin connected to the BLTouch sensor pin. Most BLTouch devices | # Pin connected to the BLTouch sensor pin. Most BLTouch devices | ||
# | # |