Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
reprap:wanhao:duplicator6:troubleshooting [2018/05/16 18:15] – created champatron | reprap:wanhao:duplicator6:troubleshooting [2019/09/18 15:42] (current) – [MAKE SURE YOU READ ABOUT THE FIRE HAZARD ISSUE!] lorenbearhead | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Troubleshooting ====== | ====== Troubleshooting ====== | ||
- | MAKE SURE YOU READ ABOUT THE FIRE HAZARD ISSUE! | + | ===== MAKE SURE YOU READ ABOUT THE FIRE HAZARD ISSUE! |
+ | [[.:Fire Hazard]] | ||
+ | |||
+ | |||
+ | === ERROR - STOPPED - Temp Sensor === | ||
+ | === ERROR - STOPPED - X or Y Switch Broken === | ||
+ | === ERROR - STOPPED - Z Switch Broken === | ||
+ | === ERROR - STOPPED - Heater Error === | ||
- | ERROR - STOPPED - Temp Sensor | ||
- | ERROR - STOPPED - X or Y Switch Broken | ||
- | ERROR - STOPPED - Z Switch Broken | ||
- | ERROR - STOPPED - Heater Error | ||
1. Ensure temp probe and heater are fully and securely inserted into the heat block. There are tiny screws in the sides for you to tighten with but if that isn't helping I recommend thermal grease to get them stuck in there snug. | 1. Ensure temp probe and heater are fully and securely inserted into the heat block. There are tiny screws in the sides for you to tighten with but if that isn't helping I recommend thermal grease to get them stuck in there snug. | ||
2. Make sure the two wires from the heater and temp probe are securely connected to the board on top of the extruder. | 2. Make sure the two wires from the heater and temp probe are securely connected to the board on top of the extruder. | ||
Line 13: | Line 16: | ||
4. Remove the bottom plate cover and make sure the ribbon cable is securely connected to the motherboard. Shouldn' | 4. Remove the bottom plate cover and make sure the ribbon cable is securely connected to the motherboard. Shouldn' | ||
5. Bypass The Relay. | 5. Bypass The Relay. | ||
+ | [[https:// | ||