Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
reprap:wanhao:duplicator6:specifications [2018/05/16 18:12] – champatron | reprap:wanhao:duplicator6:specifications [2018/05/16 18:14] – champatron | ||
---|---|---|---|
Line 53: | Line 53: | ||
* Travel Speed: 30mm - 150mm/s | * Travel Speed: 30mm - 150mm/s | ||
* Extruder Temperature Range: 180degC - **200degC (Above 200degC, the PTFE tube in the heat block will begin breaking down, causing clogs and releasing toxic? gases)** | * Extruder Temperature Range: 180degC - **200degC (Above 200degC, the PTFE tube in the heat block will begin breaking down, causing clogs and releasing toxic? gases)** | ||
- | ** __HIGHLY RECOMMEND ALL METAL HOT END UPGRADE!**__ | + | |
- | + | ||
- | | + | |
Physical Dimensions: | Physical Dimensions: | ||
Line 68: | Line 66: | ||
* Ambient Operating Temperature: | * Ambient Operating Temperature: | ||
* Storage Temperature: | * Storage Temperature: | ||
- | * Average Noise Level: 49dB (Much quieter after installing motor dampers) | + | * Average Noise Level: 49dB **(Much quieter after installing motor dampers)** |
Electrical Specifications: | Electrical Specifications: | ||
* AC Outlet Input: 100-240V, 50-60Hz | * AC Outlet Input: 100-240V, 50-60Hz | ||
- | * Power Consumption: | + | * Power Consumption: |