Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
reprap:wanhao:duplicator6:major_components:motherboard [2018/07/12 04:56] – [The Relay] champatron | reprap:wanhao:duplicator6:major_components:motherboard [2018/12/02 02:27] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Motherboard Overview ====== | ====== Motherboard Overview ====== | ||
+ | |||
+ | [[https:// | ||
The motherboard for the D6 was " | The motherboard for the D6 was " | ||
Line 35: | Line 37: | ||
===== The Extruder Ribbon Connection ===== | ===== The Extruder Ribbon Connection ===== | ||
- | [TODO, I GOT A LOT] | + | {{ : |
+ | |||
+ | E-1A, | ||
+ | |||
+ | [https:// | ||
+ | |||
+ | ===== The MOSFETS ===== | ||
+ | |||
+ | |||
+ | [[https:// | ||
+ | |||
===== The T1 Chip ===== | ===== The T1 Chip ===== | ||
The T1 chip located near the extruder ribbon cable connector of the motherboard is responsible for control of both fans on the extruder. If you have no power going to either or both fan then you may need to replace or bypass this chip. Check to make sure that it is not shorted, usually they go completely open circuit so you can solder another one on top of it. Almost any NPN general purpose transistor will work in place of T-1. | The T1 chip located near the extruder ribbon cable connector of the motherboard is responsible for control of both fans on the extruder. If you have no power going to either or both fan then you may need to replace or bypass this chip. Check to make sure that it is not shorted, usually they go completely open circuit so you can solder another one on top of it. Almost any NPN general purpose transistor will work in place of T-1. |