Differences

This shows you the differences between two versions of the page.

--- reprap:firmware:anet:repetier:install [2017/01/09 17:07] – lokster
+++ reprap:firmware:anet:repetier:install [2017/03/09 10:02] – lokster
@@ Line 37: / Line 37: @@
 to
 <code cpp>#define X_MIN_POS -32</code>
+And a couple of more parameters. Set them to the following values:
+(use PID control for the extruder)
+<code cpp>#define EXT0_HEAT_MANAGER 1
+#define EXT0_PID_PGAIN_OR_DEAD_TIME 19.58
+#define EXT0_PID_I 1.71
+#define EXT0_PID_D 55.94</code>
+(define the proper the X/Y axis lengths)
+<code cpp>#define X_MAX_LENGTH 252
+#define Y_MAX_LENGTH 227</code>
+(make the buttons/UI more responsive)
+<code cpp>#define UI_ENCODER_SPEED 0
+#define UI_KEY_BOUNCETIME 30
+#define UI_KEY_FIRST_REPEAT 250</code>
+Finally, save your changes, and hit the Upload button in Arduino IDE.