Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
reprap:firmware:anet:repetier:intro [2017/01/09 10:53] – lokster | reprap:firmware:anet:repetier:install [2017/03/09 10:02] – lokster | ||
---|---|---|---|
Line 32: | Line 32: | ||
Open the Repetier.ino located in the " | Open the Repetier.ino located in the " | ||
+ | Note: for my own Anet A8, I had to change the following parameter too, because otherwise X=0 was 6mm to the right from the edge of the bed. | ||
+ | Changed | ||
+ | <code cpp># | ||
+ | to | ||
+ | <code cpp># | ||
+ | |||
+ | And a couple of more parameters. Set them to the following values: | ||
+ | |||
+ | (use PID control for the extruder) | ||
+ | <code cpp># | ||
+ | #define EXT0_PID_PGAIN_OR_DEAD_TIME 19.58 | ||
+ | #define EXT0_PID_I 1.71 | ||
+ | #define EXT0_PID_D 55.94</ | ||
+ | |||
+ | (define the proper the X/Y axis lengths) | ||
+ | <code cpp># | ||
+ | #define Y_MAX_LENGTH 227</ | ||
+ | |||
+ | (make the buttons/UI more responsive) | ||
+ | <code cpp># | ||
+ | #define UI_KEY_BOUNCETIME 30 | ||
+ | #define UI_KEY_FIRST_REPEAT 250</ | ||
+ | |||
+ | Finally, save your changes, and hit the Upload button in Arduino IDE. |