Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revisionBoth sides next revision | ||
reprap:firmware:anet:repetier:intro [2016/12/30 11:01] – created lokster | reprap:firmware:anet:repetier:install [2017/03/09 10:00] – lokster | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Installing Repetier firmware on Anet A8 ====== | ||
+ | |||
+ | |||
To install Repetier firmware on Anet A8, you must first download it. Go to [[https:// | To install Repetier firmware on Anet A8, you must first download it. Go to [[https:// | ||
Unzip the archive when downloaded, and open the directory. Go to the " | Unzip the archive when downloaded, and open the directory. Go to the " | ||
Line 20: | Line 23: | ||
#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_X 400 | #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_X 400 | ||
#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Y 400 | #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Y 400 | ||
- | #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_X | + | #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_X |
- | #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_Y | + | #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_Y |
</ | </ | ||
Line 28: | Line 31: | ||
Just download it from [[https:// | Just download it from [[https:// | ||
Open the Repetier.ino located in the " | Open the Repetier.ino located in the " | ||
+ | |||
+ | Note: for my own Anet A8, I had to change the following parameter too, because otherwise X=0 was 6mm to the right from the edge of the bed. | ||
+ | Changed | ||
+ | <code cpp># | ||
+ | to | ||
+ | <code cpp># | ||
+ | |||
+ | And a couple of more parameters. Set them to the following values: | ||
+ | |||
+ | (use PID control for the extruder) | ||
+ | <code cpp># | ||
+ | #define EXT0_PID_PGAIN_OR_DEAD_TIME 19.58 | ||
+ | #define EXT0_PID_I 1.71 | ||
+ | #define EXT0_PID_D 55.94</ | ||
+ | |||
+ | (define the proper the X/Y axis lengths) | ||
+ | <code cpp># | ||
+ | #define Y_MAX_LENGTH 227</ | ||
+ | |||
+ | (make the buttons/UI more responsive) | ||
+ | <code cpp># | ||
+ | #define UI_KEY_BOUNCETIME 30 | ||
+ | #define UI_KEY_FIRST_REPEAT 250</ | ||
+ | |||