Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
reprap:electronics:ramps [2016/12/21 22:33] – [See also] lukeskymuh | reprap:electronics:ramps [2018/04/10 23:24] – [Why would I want to do this?] 3dguy | ||
---|---|---|---|
Line 26: | Line 26: | ||
Since a picture is worth a thousand words, here’s a picture to show you why I did it: | Since a picture is worth a thousand words, here’s a picture to show you why I did it: | ||
- | ** THIS IS WHERE A PICTURE WILL GO EVENTUALLY MAYBE. FIXME** | + | {{: |
In the event you can’t see what the photo is showing you, it’s this: The mainboard from my Anet A8 caught fire after about two weeks’ worth of printing. I am not entirely sure what caused the fire since my wiring was correct (despite some speculation from the Anet Facebook group), but I do know this: The Marlin firmware that Anet uses in their mainboards is older than the current stable version, and it lacks the basic safeguards that newer Marlin releases has. | In the event you can’t see what the photo is showing you, it’s this: The mainboard from my Anet A8 caught fire after about two weeks’ worth of printing. I am not entirely sure what caused the fire since my wiring was correct (despite some speculation from the Anet Facebook group), but I do know this: The Marlin firmware that Anet uses in their mainboards is older than the current stable version, and it lacks the basic safeguards that newer Marlin releases has. | ||
Line 221: | Line 222: | ||
====See also ==== | ====See also ==== | ||
- | * [[https:// | + | * [[https:// |
- | + | ||
- | following changes to this excelent guide are proposed: | + | |
* in configuration.h change: | * in configuration.h change: | ||
* set: #define Z_MAX_POS 240 - to use the maximum A8 height | * set: #define Z_MAX_POS 240 - to use the maximum A8 height |