Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
reprap:electronics:heatbed_mosfet [2019/08/11 17:08] – [What you need] sjouke | reprap:electronics:heatbed_mosfet [2019/08/11 17:15] (current) – [How to install] sjouke | ||
---|---|---|---|
Line 32: | Line 32: | ||
{{ : | {{ : | ||
- | NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards. | + | NOTE: More than one version of the ANET controlboard is being shipped from China (with and without version nummers), always check for + and - (polarity) on the boards. |
* RED | * RED | ||
* BLACK = - (on psu marked as -V or COM ) | * BLACK = - (on psu marked as -V or COM ) | ||
Line 71: | Line 71: | ||
==== Apply a second Mosfet (for the extruder) ==== | ==== Apply a second Mosfet (for the extruder) ==== | ||
- | If you decide you want to use a mosfet for your extruder as well, here is a schematic you might find usefull | + | Eventhough in my opinion it is not really necessary, |
{{ : | {{ : |