Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| reprap:electronics:heatbed_mosfet [2019/08/11 16:52] – [How to install] sjouke | reprap:electronics:heatbed_mosfet [2019/08/11 17:15] (current) – [How to install] sjouke | ||
|---|---|---|---|
| Line 22: | Line 22: | ||
| {{: | {{: | ||
| Note: Some mosfets are sold with the signal wire, some without, check if you need to buy a separate one. | Note: Some mosfets are sold with the signal wire, some without, check if you need to buy a separate one. | ||
| - | 3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[http:// | + | 3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[https:// |
| Question: Can I use a mechanical relays too? | Question: Can I use a mechanical relays too? | ||
| Line 30: | Line 30: | ||
| A special bracket to mount your ANET mainboard and 1 mosfet unit, you can find here https:// | A special bracket to mount your ANET mainboard and 1 mosfet unit, you can find here https:// | ||
| - | + | {{ : | |
| - | NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards. | + | |
| + | NOTE: More than one version of the ANET controlboard is being shipped from China (with and without version nummers), always check for + and - (polarity) on the boards. | ||
| * RED | * RED | ||
| * BLACK = - (on psu marked as -V or COM ) | * BLACK = - (on psu marked as -V or COM ) | ||
| Line 70: | Line 71: | ||
| ==== Apply a second Mosfet (for the extruder) ==== | ==== Apply a second Mosfet (for the extruder) ==== | ||
| - | If you decide you want to use a mosfet for your extruder as well, here is a schematic you might find usefull | + | Eventhough in my opinion it is not really necessary, |
| {{ : | {{ : | ||