Differences

This shows you the differences between two versions of the page.

--- reprap:electronics:heatbed_mosfet [2019/08/11 17:01] – [How to install] sjouke
+++ reprap:electronics:heatbed_mosfet [2019/08/11 17:13] – [Apply a second Mosfet (for the extruder)] sjouke
@@ Line 22: / Line 22: @@
 {{:reprap:electronics:mosfet.jpg?200|}} {{:reprap:electronics:2pin-jst.jpg?200|}} {{:reprap:electronics:red-black-copper-wire-2x1-5-led-strip-monitor-power-cabl.jpg?200|}}
    Note: Some mosfets are sold with the signal wire, some without, check if you need to buy a separate one.
-D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[http://www.banggood.com/Heated-Bed-Power-Expansion-Module-Large-Power-For-3D-Printer-Chitu-Motherboard-p-1133861.html?p=2322113070965201511G|on banggood.com]]
+D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[https://www.banggood.com/MOSFET-High-Power-Heated-Bed-Expansion-Power-Module-MOS-Tube-for-3D-Printer-Prusa-i3-Anet-A8A6-p-1356434.html?p=2322113070965201511G&custlinkid=456623|on banggood.com]]
       Question: Can I use a mechanical relays too?
@@ Line 71: / Line 71: @@
 ==== Apply a second Mosfet (for the extruder) ====
-If you decide you want to use a mosfet for your extruder as well, here is a schematic you might find usefull
+Eventhough in my opinion it is not really necessary, you might want to decide you want to use a 2nd mosfet for your extruder as well, here is a schematic you might find usefull
 {{ :reprap:electronics:2mosfet.jpg ?600 |}}