Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
reprap:electronics:heatbed_mosfet [2019/08/11 16:52] – [How to install] sjouke | reprap:electronics:heatbed_mosfet [2019/08/11 17:13] – [Apply a second Mosfet (for the extruder)] sjouke | ||
---|---|---|---|
Line 22: | Line 22: | ||
{{: | {{: | ||
Note: Some mosfets are sold with the signal wire, some without, check if you need to buy a separate one. | Note: Some mosfets are sold with the signal wire, some without, check if you need to buy a separate one. | ||
- | 3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[http:// | + | 3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[https:// |
Question: Can I use a mechanical relays too? | Question: Can I use a mechanical relays too? | ||
Line 30: | Line 30: | ||
A special bracket to mount your ANET mainboard and 1 mosfet unit, you can find here https:// | A special bracket to mount your ANET mainboard and 1 mosfet unit, you can find here https:// | ||
+ | {{ : | ||
+ | |||
NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards. | NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards. | ||
* RED | * RED | ||
Line 70: | Line 71: | ||
==== Apply a second Mosfet (for the extruder) ==== | ==== Apply a second Mosfet (for the extruder) ==== | ||
- | If you decide you want to use a mosfet for your extruder as well, here is a schematic you might find usefull | + | Eventhough in my opinion it is not really necessary, |
{{ : | {{ : |