Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| reprap:electronics:heatbed_mosfet [2019/08/11 16:52] – [How to install] sjouke | reprap:electronics:heatbed_mosfet [2019/08/11 17:08] – [What you need] sjouke | ||
|---|---|---|---|
| Line 22: | Line 22: | ||
| {{: | {{: | ||
| Note: Some mosfets are sold with the signal wire, some without, check if you need to buy a separate one. | Note: Some mosfets are sold with the signal wire, some without, check if you need to buy a separate one. | ||
| - | 3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[http:// | + | 3D-Printer-Parts-General-Add-on-Heated-Bed-Power-Expansion-Module-High-Power-Module-expansion-board[[https:// |
| Question: Can I use a mechanical relays too? | Question: Can I use a mechanical relays too? | ||
| Line 30: | Line 30: | ||
| A special bracket to mount your ANET mainboard and 1 mosfet unit, you can find here https:// | A special bracket to mount your ANET mainboard and 1 mosfet unit, you can find here https:// | ||
| + | {{ : | ||
| + | |||
| NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards. | NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards. | ||
| * RED | * RED | ||