reprap:electronics:heatbed_mosfet

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Next revisionBoth sides next revision
reprap:electronics:heatbed_mosfet [2019/08/11 16:49] – [Howto Connect your Hotbed (and or extruder) to a Mosfet] sjoukereprap:electronics:heatbed_mosfet [2019/08/11 17:01] – [How to install] sjouke
Line 29: Line 29:
 ===== How to install ===== ===== How to install =====
  
-A special bracket to mount both PCB's you can find here https://www.thingiverse.com/thing:1857006 +A special bracket to mount your ANET mainboard and 1 mosfet unit, you can find here https://www.thingiverse.com/thing:1857006 
 +{{ :reprap:anet:mosfetbracket.jpg?direct&400 |}} 
 +   
    NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards.     NOTE: More than one version of the ANET controlboard is being shipped from China, always check for + and - (polarity) on the boards. 
          * RED   =  +  (on psu marked as +V )           * RED   =  +  (on psu marked as +V ) 
  • reprap/electronics/heatbed_mosfet.txt
  • Last modified: 2019/08/11 17:15
  • by sjouke