This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |
reprap:anet:et4 [2022/03/09 00:43] – [Firmware] vidschofelix | reprap:anet:et4 [2022/03/11 01:36] (current) – [Firmware] vidschofelix |
---|
* [[https://github.com/davidtgbe/Marlin|Marlin for ET4/5 series 3D printers]] + openblt bootloader by davidtgbe | * [[https://github.com/davidtgbe/Marlin|Marlin for ET4/5 series 3D printers]] + openblt bootloader by davidtgbe |
=== Klipper === | === Klipper === |
| * [[.et4::setup-and-flash-klipper|HowTo Setup and Flash Klipper]] |
* [[https://www.youtube.com/watch?v=I6TtREwd0Yc|Klipper 3D Printer Firmware Install on the Anet ET4 - How to -]] by PHeNNeT FiLM | * [[https://www.youtube.com/watch?v=I6TtREwd0Yc|Klipper 3D Printer Firmware Install on the Anet ET4 - How to -]] by PHeNNeT FiLM |
* [[https://phennet-film.blogspot.com/2021/05/anet-et4-printercfg-this-setting-i-dont.html| Klipper Config ET4]] by PHeNNeT FiLM | * [[https://phennet-film.blogspot.com/2021/05/anet-et4-printercfg-this-setting-i-dont.html| Klipper Config ET4]] by PHeNNeT FiLM |