This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision |
reprap:anet:et4 [2022/03/06 15:38] – [Firmware] vidschofelix | reprap:anet:et4 [2022/03/11 01:36] (current) – [Firmware] vidschofelix |
---|
* [[https://github.com/anet-3d/Marlin/|Custom (unofficial) Marlin for ET4 Repo (github.com)]] | * [[https://github.com/anet-3d/Marlin/|Custom (unofficial) Marlin for ET4 Repo (github.com)]] |
* [[https://shop.anet3d.com/blogs/anet-et4-et5-3d-printer-faq/et4-open-source-marlin-firmware|How to Flash Anet ET4 to Marlin 2+ Firmware with ST-Link]] | * [[https://shop.anet3d.com/blogs/anet-et4-et5-3d-printer-faq/et4-open-source-marlin-firmware|How to Flash Anet ET4 to Marlin 2+ Firmware with ST-Link]] |
| * [[https://github.com/davidtgbe/Marlin|Marlin for ET4/5 series 3D printers]] + openblt bootloader by davidtgbe |
=== Klipper === | === Klipper === |
| * [[.et4::setup-and-flash-klipper|HowTo Setup and Flash Klipper]] |
* [[https://www.youtube.com/watch?v=I6TtREwd0Yc|Klipper 3D Printer Firmware Install on the Anet ET4 - How to -]] by PHeNNeT FiLM | * [[https://www.youtube.com/watch?v=I6TtREwd0Yc|Klipper 3D Printer Firmware Install on the Anet ET4 - How to -]] by PHeNNeT FiLM |
* [[https://phennet-film.blogspot.com/2021/05/anet-et4-printercfg-this-setting-i-dont.html| Klipper Config ET4]] by PHeNNeT FiLM | * [[https://phennet-film.blogspot.com/2021/05/anet-et4-printercfg-this-setting-i-dont.html| Klipper Config ET4]] by PHeNNeT FiLM |