Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
reprap:anet:et4:setup-and-flash-klipper [2022/03/11 11:28] – [printer config] vidschofelix | reprap:anet:et4:setup-and-flash-klipper [2022/03/11 23:58] (current) – add scres for SCREWS_TILT_CALCULATE vidschofelix | ||
---|---|---|---|
Line 93: | Line 93: | ||
baud: 115200 | baud: 115200 | ||
serial: / | serial: / | ||
+ | restart_method: | ||
[printer] | [printer] | ||
Line 133: | Line 134: | ||
[display_status] | [display_status] | ||
+ | |||
+ | [screws_tilt_adjust] | ||
+ | screw1: 10, 10 | ||
+ | screw1_name: | ||
+ | screw2: 10, 210 | ||
+ | screw2_name: | ||
+ | screw3: 210, 210 | ||
+ | screw3_name: | ||
+ | screw4: 210, 10 | ||
+ | screw4_name: | ||
+ | horizontal_move_z: | ||
+ | speed: 50. | ||
+ | screw_thread: | ||
[gcode_macro CANCEL_PRINT] | [gcode_macro CANCEL_PRINT] |