Differences

This shows you the differences between two versions of the page.

--- reprap:anet:et4:setup-and-flash-klipper [2022/03/11 03:13] – [printer config] vidschofelix
+++ reprap:anet:et4:setup-and-flash-klipper [2022/03/11 11:28] – [printer config] vidschofelix
@@ Line 14: / Line 14: @@
   * in machine -> config files add printer.cfg and open it
   * paste:
-  *<code>
+  *<file bash printer.cfg>
-# This file contains common pin mappings for the Anet ET4X printer.
+# This file contains common pin mappings for the Anet ET4 printer for klipper.
-# To use this config, the firmware should be compiled for the
-# STM32F407. When running "make menuconfig", enable "extra low-level
-# configuration setup", select (no bootloader), disable "USB for
-# communication".
-# The "make flash" command does not work on the Anet ET4. The regular
-# bootloaders cannot be used; the USB port is not connected to the MCU
-# directly, but is connected using a CH341 USB-to-serial adapter. The
-# BOOTx pins are not easily accessible.
-# Instead, the board can be programmed using the SWD interface available
-# on the J2 header of the board. The pins are unlabeled, but the first
-# three pins starting from the MCU towards the SD card slot are
-# GND, SWCLK and SWDIO.
 [stepper_x]
@@ Line 194: / Line 180: @@
     RESTORE_GCODE_STATE NAME=PAUSE_state
     BASE_RESUME
-</code>
+</file>
 (based on [[https://phennet-film.blogspot.com/2021/05/anet-et4-printercfg-this-setting-i-dont.html|PHeNNeT FiLM]])
   * save & close