This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
reprap:anet:electronics:mainboard [2017/04/26 12:00] – sjouke | reprap:anet:electronics:mainboard [2017/04/26 12:12] – sjouke |
---|
| |
* 1 potentiometer (right Z steppermotor only). | * 1 potentiometer (right Z steppermotor only). |
{{:reprap:anet:electronics:1pot.jpg?300|[[http://example.com|External Link]]}} | {{:reprap:anet:electronics:1pot.jpg?300|}} |
| |
* No potentiometers. | * No potentiometers. |
{{:reprap:anet:electronics:0pot.jpg?300|}} | {{:reprap:anet:electronics:0pot.jpg?300|}} |
| |
* changed (upgraded) powerconnectors. (note the power connections switched position as well) | * changed (upgraded) powerconnectors. (note the power supply connections switched position as well) |
| |
| {{:reprap:anet:electronics:oldconn.jpg?400|}} **⇐ OLD - NEW ⇒** {{:reprap:anet:electronics:upgrconn.jpg?100|}} |
| |
NOTE: The upgrade has been done because the "old" slide-on connectors often suffered meltdowns as a result of transitional resistance and the following heatdevelopement caused by improper wiring or currents going over the maximum rating for the connectors. | NOTE: The upgrade has been done because the "old" slide-on connectors often suffered meltdowns as a result of transitional resistance and the following heatdevelopement caused by improper wiring or currents going over the maximum rating for the connectors. |
| |
| |
{{:reprap:anet:electronics:oldconn.jpg?400|}} **⇐ OLD - NEW ⇒** {{:reprap:anet:electronics:upgrconn.jpg?100|}} | |
| |
**The general layout of the other connectors on the board stayed the same however so the picture under shows how and where to connect all plugs.** | **The general layout of the other connectors on the board stayed the same however so the picture under shows how and where to connect all plugs.** |
| |