Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
reprap:anet:anet_mainboard_overclocking [2018/01/04 05:23] – [Updating the bootloader] gmarsh23 | reprap:anet:anet_mainboard_overclocking [2018/01/04 05:30] – [Anet Motherboard Overclocking] gmarsh23 | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Anet Motherboard Overclocking ===== | ===== Anet Motherboard Overclocking ===== | ||
- | This page is a work in progress: I'm unfamiliar with the formatting syntax used on here, and I'm preparing | + | HEADS UP: This page is very much a draft, and it's definitely not easy to follow at this point. |
+ | Also, my experience developing for Atmel AVR parts is done using AVR-GCC and/or Atmel Studio, and I haven' | ||
+ | |||
+ | This is a wiki, so feel free to expand on this article or make changes as you see fit. | ||
+ | |||
+ | Thanks! | ||
==== Table of Contents ==== | ==== Table of Contents ==== | ||
Line 20: | Line 25: | ||
* pins_ANET_10.h | * pins_ANET_10.h | ||
* speed_lookuptable.h | * speed_lookuptable.h | ||
- | * Compile and install new firmware | + | * Compile and install new Marlin |
- | * Potential issues | + | |
==== Introduction ==== | ==== Introduction ==== | ||
Line 139: | Line 143: | ||
==== Marlin changes ==== | ==== Marlin changes ==== | ||
- | A number of files in Marlin have to be modified for operation at frequencies other than 16 or 20MHz. | + | A number of files in Marlin have to be modified for operation at frequencies other than 16 or 20MHz. This is in addition to the changes to the Configuration.h and Configuration_adv.h files. |
=== platformio.ini === | === platformio.ini === | ||
Line 206: | Line 210: | ||
#define ST7920_DELAY_3 DELAY_7_NOP | #define ST7920_DELAY_3 DELAY_7_NOP | ||
+ | ==== Compiling and installing new firmware ==== | ||
+ | There are many guides online describing how to compile and install Marlin on an Anet A8. Find one and link it here :) |