Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| reprap:anet:anet_mainboard_overclocking [2018/01/04 05:23] – [Updating the bootloader] gmarsh23 | reprap:anet:anet_mainboard_overclocking [2018/01/04 05:27] – [Table of Contents] gmarsh23 | ||
|---|---|---|---|
| Line 20: | Line 20: | ||
| * pins_ANET_10.h | * pins_ANET_10.h | ||
| * speed_lookuptable.h | * speed_lookuptable.h | ||
| - | * Compile and install new firmware | + | * Compile and install new Marlin |
| - | * Potential issues | + | |
| ==== Introduction ==== | ==== Introduction ==== | ||
| Line 134: | Line 133: | ||
| avrdude: safemode: efuse reads as 0 | avrdude: safemode: efuse reads as 0 | ||
| avrdude: safemode: Fuses OK (E:00, H:00, L:00) | avrdude: safemode: Fuses OK (E:00, H:00, L:00) | ||
| + | | ||
| avrdude done. Thank you. | avrdude done. Thank you. | ||
| ==== Marlin changes ==== | ==== Marlin changes ==== | ||
| - | A number of files in Marlin have to be modified for operation at frequencies other than 16 or 20MHz. | + | A number of files in Marlin have to be modified for operation at frequencies other than 16 or 20MHz. This is in addition to the changes to the Configuration.h and Configuration_adv.h files. |
| === platformio.ini === | === platformio.ini === | ||
| Line 206: | Line 205: | ||
| #define ST7920_DELAY_3 DELAY_7_NOP | #define ST7920_DELAY_3 DELAY_7_NOP | ||
| + | ==== Compiling and installing new firmware ==== | ||
| + | There are many guides online describing how to compile and install Marlin on an Anet A8. Find one and link it here :) | ||