Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
reprap:anet:a8 [2019/01/03 08:01] – [General] cj_elec_tech | reprap:anet:a8 [2019/08/11 17:44] – [Enclosure] sjouke | ||
---|---|---|---|
Line 18: | Line 18: | ||
* Assembly (Updated 2016/12/29. This video applies to A8 with new Z axis nut supports.) [[https:// | * Assembly (Updated 2016/12/29. This video applies to A8 with new Z axis nut supports.) [[https:// | ||
* Assembly (Updated 2016/12/29. This video applies to A8 with new Z axis nut supports.) [[https:// | * Assembly (Updated 2016/12/29. This video applies to A8 with new Z axis nut supports.) [[https:// | ||
- | * [[https:// | + | * Initial setup after assembly and Debugging Video [[https:// |
* [[https:// | * [[https:// | ||
- | * [[https:// | + | * [[https:// |
==== Additional assembly instructions ==== | ==== Additional assembly instructions ==== | ||
These are the most asked questions when assembling | These are the most asked questions when assembling | ||
Line 42: | Line 42: | ||
==== General ==== | ==== General ==== | ||
* [[https:// | * [[https:// | ||
- | * [[reprap: | + | * [[reprap: |
* [[reprap: | * [[reprap: | ||
* [[https:// | * [[https:// | ||
Line 199: | Line 199: | ||
- | ==== To be written | + | ==== ATX psu (partly covered in ....) ==== |
- | * [[reprap: | + | |
+ | * [[reprap: | ||
===== Replacement parts ===== | ===== Replacement parts ===== | ||
Line 229: | Line 229: | ||
* Polish facebook Group[[https:// | * Polish facebook Group[[https:// | ||
* Anet A8 Prusa i3 [[http:// | * Anet A8 Prusa i3 [[http:// | ||
+ | * Fedora Special Interest Group for 3D Printing (not ANET-centric, | ||
+ | * r/ | ||