Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
reprap:anet:a8:replace_hb_connector [2018/08/04 15:44] – [Option 2 - Soldering the wires directly onto the hotbed heater] sjouke | reprap:anet:a8:replace_hb_connector [2021/09/02 21:58] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 6: | Line 6: | ||
{{ : | {{ : | ||
- | For problems on the other end of theese | + | For problems on the other end of these wires look here https:// |
==== Root cause ==== | ==== Root cause ==== | ||
There are several opinions about the root cause of this problem. Which is the main root cause or if it is a combination of them is still to be [[https:// | There are several opinions about the root cause of this problem. Which is the main root cause or if it is a combination of them is still to be [[https:// | ||
Line 85: | Line 85: | ||
then maybe 15 degrees spread out over ca 30 cm. therefore hardly any bending at all in a specific place and furthermore eliminating the | then maybe 15 degrees spread out over ca 30 cm. therefore hardly any bending at all in a specific place and furthermore eliminating the | ||
need for the other mentioned angled connector(s). (Why overengeneer things?) | need for the other mentioned angled connector(s). (Why overengeneer things?) | ||
+ | | ||
===== Remarks: ===== | ===== Remarks: ===== |