reprap:anet:a8:replace_hb_connector

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
Next revisionBoth sides next revision
reprap:anet:a8:replace_hb_connector [2018/08/04 15:44] – [Option 2 - Soldering the wires directly onto the hotbed heater] sjoukereprap:anet:a8:replace_hb_connector [2018/12/02 02:27] – external edit 127.0.0.1
Line 6: Line 6:
 {{ :reprap:anet:a8:18449265_10211516226635514_3997977419206089998_o.jpg?direct&400 |}} {{ :reprap:anet:a8:18449265_10211516226635514_3997977419206089998_o.jpg?direct&400 |}}
  
-For problems on the other end of theese wires look here https://3dprint.wiki/reprap/electronics/heatbed_mosfet+For problems on the other end of these wires look here https://3dprint.wiki/reprap/electronics/heatbed_mosfet
 ==== Root cause ==== ==== Root cause ====
 There are several opinions about the root cause of this problem. Which is the main root cause or if it is a combination of them is still to be [[https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup/permalink/662020787319819/|discussed]]. Here some collected facts and arguments. There are several opinions about the root cause of this problem. Which is the main root cause or if it is a combination of them is still to be [[https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup/permalink/662020787319819/|discussed]]. Here some collected facts and arguments.
  • reprap/anet/a8/replace_hb_connector.txt
  • Last modified: 2021/09/02 21:59
  • by 127.0.0.1