reprap:anet:a8:replace_hb_connector

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
reprap:anet:a8:replace_hb_connector [2018/08/04 15:44] – [Option 2 - Soldering the wires directly onto the hotbed heater] sjoukereprap:anet:a8:replace_hb_connector [2018/08/04 15:49] – [Replacing the hotbed connector] sjouke
Line 6: Line 6:
 {{ :reprap:anet:a8:18449265_10211516226635514_3997977419206089998_o.jpg?direct&400 |}} {{ :reprap:anet:a8:18449265_10211516226635514_3997977419206089998_o.jpg?direct&400 |}}
  
-For problems on the other end of theese wires look here https://3dprint.wiki/reprap/electronics/heatbed_mosfet+For problems on the other end of these wires look here https://3dprint.wiki/reprap/electronics/heatbed_mosfet
 ==== Root cause ==== ==== Root cause ====
 There are several opinions about the root cause of this problem. Which is the main root cause or if it is a combination of them is still to be [[https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup/permalink/662020787319819/|discussed]]. Here some collected facts and arguments. There are several opinions about the root cause of this problem. Which is the main root cause or if it is a combination of them is still to be [[https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup/permalink/662020787319819/|discussed]]. Here some collected facts and arguments.
  • reprap/anet/a8/replace_hb_connector.txt
  • Last modified: 2021/09/02 21:59
  • by 127.0.0.1