Differences

This shows you the differences between two versions of the page.

--- reprap:anet:a8:replace_hb_connector [2018/08/04 15:42] – [Option 4 - european style screw connectors] sjouke
+++ reprap:anet:a8:replace_hb_connector [2018/08/04 15:49] – [Replacing the hotbed connector] sjouke
@@ Line 6: / Line 6: @@
 {{ :reprap:anet:a8:18449265_10211516226635514_3997977419206089998_o.jpg?direct&400 |}}
-For problems on the other end of theese wires look here https://3dprint.wiki/reprap/electronics/heatbed_mosfet
+For problems on the other end of these wires look here https://3dprint.wiki/reprap/electronics/heatbed_mosfet
 ==== Root cause ====
 There are several opinions about the root cause of this problem. Which is the main root cause or if it is a combination of them is still to be [[https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup/permalink/662020787319819/|discussed]]. Here some collected facts and arguments.
@@ Line 63: / Line 63: @@
   *  The solder on the heat bed is probably lead free solder. Most people use leaded solder at home. As mixing them is not recommended it is better to remove as much old solder as possible before soldering.
-  *  Foresee a strain relief so that the constant bending of the wire does not stress the solderjoint
+  *  Maybe add a strain relief so that the constant bending of the wire does not stress the solderjoint.
-[[https://www.youtube.com/watch?v=8XAr6ac-lLU&feature=youtu.be|video of a heat bed soldering]]
+[[https://www.youtube.com/watch?v=8XAr6ac-lLU&feature=youtu.be|video of a heat bed soldering]] it might be a slow going video but a lot can be learned for thoose who never practised soldering before.
 ==== Option 3 - spade connectors ====