Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
reprap:anet:a8:layer-heights [2017/01/20 08:20] nerolauda |
reprap:anet:a8:layer-heights [2018/12/02 01:27] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Valid Layer Heights ====== | + | ====== Optimal Layer Heights ====== |
- | Based on the pitch 2.0 mm of **the default Anet A8 Z-Axis leadscrew** 300mm T8, the Z-Motor 200 steps per revolution , and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of valid layer heights: ** 0.1, 0.11, 0.12 ..., 0.2,..., 0.3 **. | + | |
- | In phew words you can proceed by 0.01 steps. | + | Based on the lead of the Anet A8 Z-Axis leadscrews (8mm - each full rotation moves the Z-Axis 8mm), the Z-Motor steps per revolution (200), and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of optimal layer heights: **0.08, 0.12, 0.16, 0.20, 0.24, 0.28, 0.32** etc. - in increments of 0.04mm. |
+ | The leadscrews are T8 - with lead 8mm, pitch 2mm and 4 screw threads. | ||
+ | |||
+ | Note to editors: [[https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup/permalink/620740658114499/|discuss here]] before changing. | ||
- | Instead if you adopted threaded rods M8, the pitch is 1.25mm and valid layer heights are: ** 0.0125, ..., 0.025,..., 0.05, ...,0.1, ... ,0.2, ...** each sum or multiple of this values are exact steps counts. | ||
- | PLS DO NOT RESTORE WRONG VALUES |