reprap:anet:a8:layer-heights

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revisionBoth sides next revision
reprap:anet:a8:layer-heights [2017/01/20 09:19] nerolaudareprap:anet:a8:layer-heights [2017/02/15 14:39] – old revision restored (2016/12/28 22:14) lokster
Line 1: Line 1:
-====== Valid Layer Heights ====== +====== Optimal Layer Heights ====== 
-Based on the pitch 2.0 mm of the default Anet A8 Z-Axis **leadscrew** 300mm T8, the Z-Motor 200 steps per revolution , and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of valid layer heights: ** 0.1, 0.11, 0.12 ..., 0.2,..., 0.**. + 
-In phew words you can proceed by 0.01 steps.+Based on the lead of the Anet A8 Z-Axis leadscrews (8mm - each full rotation moves the Z-Axis 8mm), the Z-Motor steps per revolution (200), and [[http://prusaprinters.org/calculator/#optimallayer|this calculator]], we can calculate the list of optimal layer heights: **0.08, 0.12, 0.16, 0.20, 0.240.28, 0.32** etc- in increments of 0.04mm. 
 +The leadscrews are T8 - with lead 8mm, pitch 2mm and 4 screw threads. 
 + 
 +Note to editors: [[https://www.facebook.com/groups/OFFICIALAnet3DprinterSupportGroup/permalink/620740658114499/|discuss here]] before changing.
  
-Instead if you adopted threaded rods M8, the pitch is 1.25mm and valid layer heights are: ** 0.0125, ..., 0.025,..., 0.05, ...,0.1, ... ,0.2, ...** each sum or multiple of this values are exact steps counts. 
  
-PLS DO NOT RESTORE WRONG VALUES 
  • reprap/anet/a8/layer-heights.txt
  • Last modified: 2018/12/02 02:27
  • by 127.0.0.1